Waterproofing Sealer
Non-Toxic, Non Flammable
Mold and Mildew Resistant, Dries Clear

Super Seal is a specially formulated waterborne water repellant coating for just about any surface. Its special formulation provides an alternative to the solvent-based water repellant coatings that contain silicones and waxes.

Super Seal provides excellent sealing and water-beading properties, reduces water absorption and allows wood to expand and contract naturally without flaking or peeling. Super Seal provides superior breathing properties and is VOC compliant. Unlike most other clear coatings, this coating may be painted over with latex or oil base paints. Meets ASTM D4446 specification pertaining to swelling of wood and Federal Specification SSW-110 C for water repellency.

 Contains No Silicones...No Waxes...Interior or Exterior Use... Environmentally Safe!

Suggested Uses:
Wood Siding, Decks, Fences, and Shingles - Masonite - Cedar Siding - Roof Tiles - Dryvit, EIFS, colored Stucco - Stone - Brick - Cement - Stucco - Concrete Block - Masonry - Plaster - Grout - Canvas - Simulated brick and stone

APPLICATION :
The surface should be clean, dry and free from all dirt, grease, oils, waxes, mildew, curing agents, and other surface contaminants that may cause coating failure.
Remove all loose and peeling paint and lightly sand glossy surfaces.
Super Seal is supplied ready to use. DO NOT THIN. Mix thoroughly prior to use.
Easily applied with a quality brush, roller, airless spray and low pressure hand pump sprayer.
Always apply material to test panel prior to general application.

Vertical Surfaces: Start first coat application at the top of the area to be coated.
Apply flood coat with a 6"-8" rundown and back-roll material into surface voids.
Apply second coat before the first coat dries completely to insure complete saturation of the surface. Remove excess material with a clean dry roller.

Horizontal Surfaces: Apply 2 wet on wet coats. The first coat should be applied until the surface is saturated to create a deep bond. The second coat can be a lighter application since the pores of the surface are already filled. Remove excess standing or ponding material with a clean dry roller.

Coverage: Covers approximately 200-300 square feet per gallon depending on
type of application and porosity of the surface to be treated.
Dry Time: Dries to the touch in 1 - 2 hours,
may be re coated in 3 - 4 hours depending on conditions.
Clean up any spills, painting tools and equipment with warm soapy water.
Available in 1 Gal, 5 Gal, and 55 Gal drums
$30.50 Per Gal...5 Gallon $152.50

  Or 

Order |  Painting Tips |  Shipping |  International |  Questions? |  Site Map |  HOME